NAD C 356BEE STEREO INTEGRATED AMPLIFIER
From the manufacturer:
The C 356BEE symbolises NAD’s desire for continual improvement—even on an award-winning design. We have refined our amplifier performance and added more value to our C 356BEE design by applying knowledge gained from our top-of-the-line Masters Series M3 Amplifier. Able to drive the most complex loudspeakers to their full musical potential, the C 356BEE can challenge amplifiers costing two to three times more. With features like Preamp Out and Modular Design Construction, this amp can be customised to suit your specific requirements.
With the very high dynamic power and low impedance drive capability of our NAD PowerDrive™ circuit, the C 356BEE is able to accurately control difficult to drive
loudspeakers while sounding musical, detailed, coherent and relaxed. Even at elevated listening levels, our exclusive Soft Clipping feature is there to save both your ears and your speakers from damaging clipping distortion.
The C 356BEE has the lowest levels of distortion and noise available in its price class and is easily capable of embarrassing far more expensive products. To prove it we use Full Disclosure Power (FDP), the most demanding criterion for performance measurement. FDP specifies distortion under the most extreme conditions of low impedance loads and frequency extremes rather than the simple and easy 1kHz @ 8 ohms test quoted by many of our competitors. We use this stricter performance criterion because it more closely matches the demands of real music and real loudspeakers. Maintaining specified distortion at 4 ohms and at 20Hz and 20kHz is a much more difficult achievement.
Musical performance is only part of the C 356BEE’s story. We have also included our upgrade-friendly Modular Design Construction (MDC) to allow the addition of our superb PP 375 Phono Stage and MDC DAC - USB Digital Analogue Converter or other yet-to-be-announced MDC Modules to enhance the capabilities of this affordable amplifier.
Since the C 356BEE is fitted with one MDC slot, if you are looking at add both of these functions, our recommended configuration is to install an MDC DAC and use an outboard-connected PP2 or PP3 for Phono. Recently, NAD has added a C 356BEE model that has the MDC DAC fully installed in the factory, called the C 356BEE DAC.
Why to buy:
* PowerDrive™ circuitry
* Lowest levels of distortion and noise in its price class
* Modular Design Construction
* Improved speaker binding posts
* Two pairs of speakers with remote controlled switching
* Sonically transparent sealed reed relay switches for all inputs
* Front panel mini-jack
* Internal architecture minimizes signal path length
* Musically satisfying tone controls
* Wireless remote
* Continuous output power into 8 ohm and 4 ohm (Stereo): >80W (at rated THD, 20Hz-20kHz, both channels driven)
* THD* 20 Hz - 20 kHz, CCIF IMD, SMPTE IMD, DIM 100: <0.009% (250 mW to 80 W, 8 ohm and 4 ohm)
* Clipping Power: >90
Find even more on Junk Mail by browsing through the similar ads below.